Clutch Removal - Honda Transalp XL700V Manual

CLUTCH/GEARSHIFT LINKAGE
INSPECTION
Check the oil seal for fatigue or damage.
Check the needle bearings for wear, damage or
loose fit.
Replace these parts if necessary.
If the oil seal replacement is required, install the oil
seal to the case surface.
Check the clutch lifter arm for wear, damage or
bending.
Check the spring for fatigue or damage.
Replace it if necessary.

CLUTCH REMOVAL

REMOVAL
Remove the right crankcase cover (page 10-5).
If the oil pump driven sprocket will be removed,
loosen the driven sprocket bolt while the clutch is
still installed.
Remove the clutch lifter piece from the lifter bear-
ing.
10-6
NEEDLE BEARING
LIFTER ARM
DRIVEN SPROCKET BOLT
CLUTCH LIFTER PIECE
OIL SEAL
BEARING