Honda Transalp XL700V Manual page 277

CYLINDER HEAD/VALVES
Then check the identification mark "R" on the rear
camshaft.
– If the "R" mark faces up, turn the crankshaft
counterclockwise 1-16/45 (488°) turn (align the
"FT" mark on the flywheel with the index notch)
and begin installation of the front camshaft.
– If the "R" mark faces down (cannot be seen), turn
the crankshaft counterclockwise 16/45 (128°) turn
(align the "FT" mark with the index notch) and
begin installation of the front camshaft.
Install the front camshaft (page 8-31).
BOTH CYLINDER TDC SETTING
Align the "FT" mark on the flywheel with the index
If both camshafts
notch on the left crankcase cover.
have been serviced,
begin installation of
Install the front camshaft (page 8-31).
the front camshaft.
Set the rear cylinder at TDC (page 8-30).
Install the rear camshaft (page 8-31).
REAR CYLINDER TDC SETTING
Remove the front cylinder head cover (page 8-6).
If the front cylinder
Check the front cylinder camshaft position as fol-
has not been
lows:
serviced, begin
here.
Turn the crankshaft counterclockwise and align the
"FT" mark on the flywheel with the index notch on
the left crankcase cover.
Then check the identification mark "F" on the front
camshaft.
– If the "F" mark faces up, turn the crankshaft coun-
terclockwise 29/45 (232°) turn (align the "RT"
mark on the flywheel with the index notch) and
begin installation of the rear camshaft.
– If the "F" mark faces down (cannot be seen), turn
the crankshaft clockwise 1-29/45 (592°) turn
(align the "RT" mark with the index notch) and
begin installation of the rear camshaft.
Install the rear camshaft using the following proce-
dure.
8-30
INDEX NOTCH
"FT" MARK
INDEX NOTCH
"FT" MARK
"R" MARK
"F" MARK