Honda Transalp XL700V Manual page 178

2. Injector Resistance Inspection
Turn the ignition switch OFF.
Measure the resistance of the injector connector
terminals.
STANDARD: 10 – 14 Ω (20°C/68°F)
Is the resistance within 10 – 14 Ω (20 ° C/68 ° F)?
NO – Faulty injector
YES – GO TO STEP 3.
3. Injector Signal Line Open Circuit Inspection
Connect the test harness to the ECM 33P (Black)
connector (page 5-16).
Check for continuity between the test harness
terminal and injector 2P (Gray) connector.
Connection: SIGNAL LINE – SIGNAL LINE
Is there continuity?
NO – Open circuit in SIGNAL line wire.
YES – GO TO STEP 4.
4. Injector Signal Line Short Circuit Inspection
Check for continuity between the injector 2P
(Gray) connector and ground.
Connection: SIGNAL LINE – Ground
Is there continuity?
YES – Short circuit in SIGNAL line wire
NO – Replace the ECM with a new one, and
recheck; for Key Registration Proce-
dures (page 21-4).
FUEL SYSTEM (PGM-FI)
INJECTOR (Injector side/male terminal)
FRONT INJECTOR 2P (GRAY)
CONNECTOR (Wire side/female terminal)
A6
A17
REAR INJECTOR 2P (GRAY)
CONNECTOR (Wire side/female terminal)
P/Bu or P/Y
INJECTOR 2P (GRAY) CONNECTOR
(Wire side/female terminal)
P/Y
P/Bu
5-47