Honda Transalp XL700V Manual page 341

CRANKCASE/CRANKSHAFT/TRANSMISSION
Apply engine oil to the bearing cap nut threads and
Do not rotate the
seating surfaces, then tighten them to the specified
crankshaft during
torque in several steps alternately.
inspection.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Remove the bearing caps and measure the com-
pressed plastigauge at its widest point on each
crankpin to determine the oil clearance.
SERVICE LIMIT: 0.07 mm (0.003 in)
If the clearance exceeds the service limit, select the
correct replacement bearings as follows.
BEARING SELECTION
Record the connecting rod I.D. code number.
Number 1 or 2 on the connecting rod is the code for
the connecting rod I.D.
12-12
PLASTIGAUGES
CONNECTING ROD I.D. CODE NUMBER