Handlebar - Honda Transalp XL700V Manual

Install the front brake hose clamp and tighten the
bolt securely.
Route the hose, wires and cables into the cable
guides properly (page 1-21).
Connect the immobilizer 4P (Natural) connector and
ignition switch 2P (Brown) connector.
Install the wires to the clamp.
Install the following:
– Front wheel (page 13-20)
– Front fender (page 2-13)
– Handlebar (page 13-11)
– Right front side cowl (page 2-9)
STEERING HEAD BEARING PRE-LOAD
Support the motorcycle securely and raise the front
wheel off the ground.
Position the steering stem straight ahead.
Hook a spring scale to the fork tube between the
Make sure there is
fork top and bottom bridges.
no cable, wire
harness or hose
Pull the spring scale keeping it at a right angle to the
interference.
steering stem.
Read the scale at the point where the steering stem
just starts to move.
STEERING HEAD BEARING PRE-LOAD:
10.8 – 15.7 N (1.1 – 1.6 kgf)
If the readings do not fall within the limits, readjust
the steering top thread.
FRONT WHEEL/SUSPENSION/STEERING
CLAMP
BOLT
4P (NATURAL) CONNECTOR
2P (BROWN) CONNECTOR CLAMP
90°
13-37