REAR WHEEL/SUSPENSION
Remove the lower mounting bolt.
Remove the upper mounting bolt and nut.
Remove the shock absorber.
INSPECTION
Visually inspect the damper unit for damage.
Check for the:
– Damper rod for bend or damage
– Damper unit for deformation or oil leaks
– Rubber bumper for wear or damage
Inspect all the other parts for wear or damage.
If necessary, replace the shock absorber as an
assembly.
INSTALLED SPRING LENGTH: 197.4 mm (7.77 in)
TORQUE:
Shock absorber pre-load adjuster lock nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
SHOCK ABSORBER DISPOSAL
PROCEDURE
Remove the shock absorber reservoir valve core
Do not remove the
cap.
valve core until
pressure is
Put on safety glosses, then release the nitrogen
released.
form the reservoir by depressing the valve core.
• Point the valve away from you to prevent debris
getting in your eyes.
• Before disposal of the shock absorber, release
the nitrogen by pressing the valve core. Then
remove the valve from the shock absorber reser-
voir.
14-14
LOWER MOUNTING BOLT
UPPER MOUNTING BOLT/NUT
CAP
197.4 mm (7.77 in)
VALVE CORE