Honda Transalp XL700V Manual page 411

Hide thumbs Also See for Transalp XL700V:

Table of Contents

REAR WHEEL/SUSPENSION

Install the brake disc with its rotating direction mark

Do not get grease

on the brake disc or

stopping power will

Install new bolts and tighten them in a crisscross

pattern in several steps.

TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)

Install the pulser ring onto the right wheel hub, then

tighten new torx bolts to the specified torque.

TORQUE: 8 N·m (0.8 kgf·m, 5.9 lbf·ft)

Apply grease to new dust seal lips and install the

dust seal until it is flash with the wheel hub.

Install the damper rubbers into the wheel hub.

Apply grease to a new O-ring and driven flange-to-

rear wheel hub mating surface.

Install a new O-ring into the groove of the wheel

If the driven sprocket is removed, apply engine oil

to the driven sprocket nut threads and install the

driven sprocket bolts, sprocket, washers and nuts

onto the driven flange.

Install the driven flange assembly into the left wheel

If the driven sprocket is removed, tighten the driven

sprocket nuts to the specified torque.

TORQUE: 45 N·m (4.6 kgf·m, 33 lbf·ft)

Apply grease to a new dust seal lips, then install it

into the driven flange.

DIRECTION MARK

DAMPER RUBBERS

Show Quick Links

Chapters

Table of Contents

Transalp xl700va