Honda Transalp XL700V Manual page 461

HYDRAULIC BRAKE
ASSEMBLY
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
BRAKE PADS
PAD SPRING
Coat new piston seals with clean brake fluid, and
install them into the seal grooves in the caliper.
Coat new dust seals with silicone grease and install
them into the seal grooves in the caliper.
Coat the caliper pistons with clean brake fluid and
install them into the caliper cylinders with the open-
ing toward the pads.
Check the caliper pin boot and replace it if it is hard,
deteriorated or damaged.
Install the caliper pin boot in the bracket.
If the bracket pin is removed, apply locking agent to
the threads and tighten it.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the retainer onto the bracket.
15-32
CALIPER PIN BOOT
PISTON SEAL
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
18 N·m (1.8 kgf·m, 13 lbf·ft)
BOOT
BRACKET
CALIPER BRACKET
PAD REATAINER
BRACKET PIN BOOT
PISTON
DUST SEAL
PISTON SEALS
DUST SEALS
PAD REATAINER
PISTONS
PIN