Honda Transalp XL700V Manual page 424

Press the right side pivot bearings and distance col-
lar out of the swingarm pivot using the special
tools.
TOOLS:
Driver handle
Attachment, 22 x 24 mm
Pilot, 17 mm
Pack new bearings with specified grease (page 1-
18).
Press the inner bearing in right side pivot with the
marking side facing up until it seat.
Install the distance collar, then press the outer bear-
ing with the marking side facing up until it seat,
using the special tools.
TOOLS:
Driver
Attachment, 32 x 35 mm
Pilot, 17 mm
Install the snap ring into the groove securely.
• Always install the snap ring with the chamfered
(rolled) edge facing away from the thrust load.
LEFT SIDE
Remove the left side pivot needle bearing using the
special tools.
TOOLS:
Bearing remover shaft, 25 mm
Remover weight
DRIVER HANDLE
070GD-0010100
07746-0010800
07746-0040400
BEARINGS
DRIVER
07749-0010000
07746-0010100
07746-0040400
DISTANCE COLLAR
REMOVER SHAFT
07936-ZV10100
07741-0010201
WEIGHT
REAR WHEEL/SUSPENSION
ATTACHMENT/PILOT
ATTACHMENT/PILOT
BEARINGS
SNAP RING
NEEDLE BEARING
14-25