Honda Transalp XL700V Manual page 387

FRONT WHEEL/SUSPENSION/STEERING
Set the fork tube in V-blocks and measure the fork
tube runout with a dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMIT: 0.20 mm (0.008 in)
Visually inspect the slider and tube bushings.
Replace the bushings if there is excessive scoring or
scratching, or if the teflon is worn so the copper sur-
face appears on more than 3/4 of the entire surface.
Check the back-up ring; replace it if there is any dis-
tortion at the points shown.
ASSEMBLY
Before assembly, wash all parts with a high flash
point or non-flammable solvent and wipe them off
completely.
DUST SEAL
STOPPER RING
OIL SEAL
BACK-UP RING
SLIDER BUSHING
FORK SLIDER
SEALING WASHER
20 N·m (2.0 kgf·m, 15 lbf·ft)
13-26
PISTON RING
FORK TUBE BUSHING
OIL LOCK PIECE
BUSHING
COPPER SURFACES
22 N·m (2.2 kgf·m, 16 lbf·ft)
REBOUND SPRING
BACK-UP RING
Check points
O-RING
FORK SPRING
FORK TUBE
FORK PISTON