ENGINE REMOVAL/INSTALLATION
Disconnect the air supply hoses from the PAIR
check valve covers.
Remove the clutch cable holder bolt and disconnect
the clutch cable end from the clutch lifter arm.
Remove the rubber cap and starter motor terminal
nut.
Disconnect the starter motor cable.
Remove the bolt and disconnect the ground cable.
Loosen the band screws and disconnect the water
hoses.
7-6
Front:
Rear:
AIR SUPPLY HOSES
CLUTCH CABLE HOLDER
CLUTCH CABLE
STARTER MOTOR CABLE
RUBBER CAP
WATER HOSES
BOLT
NUT
BOLT
GROUND CABLE
BAND SCREWS