Honda Transalp XL700V Manual page 380

Drive in a new left bearing squarely with the marked
side facing up until it is fully seated.
Install the distance collar.
Drive in a new right bearing squarely with the
marked side facing up until it is seated on the collar.
TOOLS:
Left side:
Driver
Attachment, 37 x 40 mm
Pilot, 17 mm
Right side:
Driver
Attachment, 42 x 47 mm
Pilot, 17 mm
ASSEMBLY
42 N·m (4.3 kgf·m, 31 lbf·ft)
BRAKE DISC
HUB COVER
DUST SEAL
Place the wheel rim on the work bench.
Place the wheel hub in the center of the rim and
begin lacing with new spokes.
Adjust the wheel hub position so that the distance
from the wheel hub right end surface to the side of
rim is 18.3 ± 1.0 mm (0.72 ± 0.04 in) as shown.
TOOL:
Spoke wrench, 6.1 mm
TORQUE: 3.7 N·m (0.4 kgf·m, 2.7 lbf·ft)
Check the rim runout (page 13-16).
FRONT WHEEL/SUSPENSION/STEERING
07749-0010000
07746-0010200
07746-0040400
07749-0010000
07746-0010300
PILOT
07746-0040400
BEARING
(6303UU)
DISTANCE COLLAR
BEARING
(6203UU)
07JMA-MR60100
DUST SEAL
HUB COVER
FRONT PULSER RING
(XL700VA)
BRAKE DISC
8 N·m (0.8 kgf·m, 5.9 lbf·ft)
42 N·m (4.3 kgf·m, 31 lbf·ft)
18.3 ± 1.0 mm
(0.72 ± 0.04 in)
DRIVER
ATTACHMENT
13-19