CYLINDER HEAD/VALVES
Check the condition of the rubber seals, replace
them if necessary.
Install the rubber seals onto the cylinder head cover
in the direction as shown.
Install the washers.
Install and tighten the cylinder head cover bolts to
the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Connect the air supply hose to the PAIR check valve
Front cylinder only:
cover.
Install the wire harness cover stay and bolt.
Rear cylinder only:
Tighten the bolt securely.
Install the following:
– Throttle body (page 5-68)
– PAIR solenoid valve (page 5-83)
– Right air guide (page 2-10)
8-34
RUBBER SEAL
BOLTS/WASHERS/RUBBER SEALS
AIR SUPPLY HOSE
STAY
UP
BOLT