Clutch Switch; Fuel Gauge/Fuel Level Sensor - Honda CBR125R Owner's Manual

LIGHTS/METERS/SWITCHES

CLUTCH SWITCH

Disconnect the clutch switch wire connectors and
check for continuity between the switch terminals.
There should be continuity with the clutch lever
squeezed and no continuity with the clutch lever
released.

FUEL GAUGE/FUEL LEVEL SENSOR

INSPECTION
FUEL GAUGE
Remove the fuel pump unit (page 5-49).
Connect the fuel pump unit 5P connector.
Turn the ignition switch ON.
Move the float from empty to full, then check the
fuel gauge needle.
If the needle does not move, check for following:
– Open or short circuit in Yellow/green wire
– Open or short circuit in White/green line
– Blown main fuse
– Blown sub fuse
– Faulty main relay (page 19-22)
– Open circuit in Green wire
If the wires are normal, inspect the fuel level sensor
(page 19-21).
If the fuel level sensor is normal, replace the fuel
gauge with a new one (page 19-10).
19-20
CLUTCH SWITCH
FUEL GAUGE
FULL
EMPTY
Y/W
G
W/G