Honda Transalp XL700V Manual page 473

Hide thumbs Also See for Transalp XL700V:

Table of Contents

HYDRAULIC BRAKE

Coat a new piston seal with clean brake fluid and

install it into the seal groove in the caliper.

Coat a new dust seal with silicone grease and install

into the seal groove in the caliper.

Coat the caliper pistons with clean brake fluid and

install them into the caliper cylinders with the open-

ing toward the pads.

Check the caliper boot and replace it if it is hard,

deteriorated or damaged.

Apply silicone grease to the caliper sleeve outer sur-

Install the caliper boot, sleeve and pad spring in the

If the caliper pin bolt is removed, tighten it to the

specified torque.

TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)

Check that the pad retainer is in place on the caliper

Install the slide pin boot into the caliper bracket.

INSTALLATION

Check the bracket boot and replace it if it is hard,

deteriorated or damage.

Apply silicone grease to the caliper pin bolt sliding

Install the rear brake caliper to the bracket.

PAD REATAINER

Show Quick Links

Chapters

Table of Contents

Transalp xl700va