Honda Transalp XL700V Manual page 405

REAR WHEEL/SUSPENSION
REAR WHEEL
REMOVAL
Support the motorcycle securely and raise the rear
wheel off the ground.
Fully slacken the drive chain (page 3-17).
Remove the axle nut and setting plate.
• Do not operate the brake pedal after removing
the wheel. To do so will cause difficulty in fitting
the brake disc between the brake pads.
Push the rear wheel forward.
Remove the rear axle and setting plate.
Derail the drive chain from the drive sprocket.
Remove the rear wheel.
• Be careful not to damage the VS sensor when
removing the wheel.
Remove the side collars.
INSPECTION
AXLE
Set the rear axle in V-blocks.
Turn the axle and measure the runout using a dial
indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMIT: 0.20 mm (0.008 in)
14-6
SETTING PLATE
COLLARS
AXLE
AXLE NUT
SETTING PLATE
AXLE
DRIVE CHAIN