COOLING SYSTEM
Align the bolt holes in the pump and crankcase, and
install the water pump cover with the bolts and a
new sealing washer.
Tighten the bolts in a crisscross pattern in several
steps.
TORQUE: 13 N·m (1.3 kgf·m, 10 lbf·ft)
Connect the water hoses.
Tighten the band screws to the specified range
(page 6-10).
Fill and bleed the cooling system (page 6-7).
Install the drive sprocket cover (page 7-13).
RADIATOR RESERVE TANK
REMOVAL/INSTALLATION
Remove the shock absorber (page 14-13).
Disconnect the siphon hose and overflow hose from
the reserve tank and drain the reserve coolant.
Remove the bolt and release the boss from the
grommet.
Installation is in the reverse order of removal.
Route the hoses
properly (page 1-
21).
6-16
WATER PUMP COVER
BOLT/SEALING WASHER
WATER HOSES
GROMMET
BOLTS
BOSS
OVERFLOW HOSE
BOLTS
SIPHON HOSE
TANK