Abs Indicator Problem Code - Honda Transalp XL700V Manual

Hide thumbs Also See for Transalp XL700V:
Table of Contents

Advertisement

ANTI-LOCK BRAKE SYSTEM (ABS)
PROBLEM CODE INDICATION PATTERN
• The ABS indicator indicates the problem code by blinking a specified number of times.
The indicator has two types of blinkings, a long blink and short blink. The long blink lasts for 1.3 sec-
onds, the short blink lasts for 0.3 seconds. When two long blinks occur, and three short blinks, that
problem code is 23 (two long blinks = 20 blinks, three short blinks = 3 blinks). Then, go to trouble-
shooting and see problem code 23.
• When the ABS control unit stores six problem codes, the ABS indicator shows the problem codes in
the order from the latest problem code to earliest problem code.
IGNITION
SWITCH
ABS
INDICATOR
When the problem code is not stored:
ABS
INDICATOR
PROBLEM CODE READOUT
• The problem code is not erased by turning the ignition switch OFF while the problem code is being
output. Note that turning the ignition switch ON again does not indicate the problem code. To show
the problem code again, repeat the problem code retrieval procedures from the beginning. Do not
apply the front or rear brake during retrieval.
• After diagnostic troubleshooting, erase the problem code(s) and perform the pre-start self-diagnosis
to be sure that there is no problem in the ABS indicator (indicator is operating normally).
1. Remove the left side cover (page 2-4).
Turn the ignition switch OFF.
Disconnect the dummy connector from the ABS
service check 3P (Natural) connector.
Short the wire terminals of the ABS service check
3P (Natural) connector with a jumper wire.
Connection: Brown/white – Green
2. Turn the ignition switch ON.
The ABS indicator starts problem code indica-
tion.
Note how many times the ABS indicator blinks,
and determine the cause of the problem (page
16-10).
16-8
ON
1.3sec.
OFF
2 sec.
3.6 sec.
ON
OFF
Problem code
start signal
Lowest number problem code
(Example: Code 12)
2 sec.
3.6 sec.
ON
OFF
0.3 sec.
0.4 sec.
3.6 sec.
0.4 sec.
Highest number problem code
(Example: Code 23)
ABS SERVICE CHECK
CONNECTOR
ABS INDICATOR
Pattern repeated
JUMPER WIRE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Transalp xl700va

Table of Contents