Honda Transalp XL700V Manual page 471

HYDRAULIC BRAKE
DISASSEMBLY
Remove the slide pin boot from the caliper bracket.
If the boot is hard, damaged or deteriorated, replace
it with a new one.
Remove the caliper boot, sleeve and pad spring
from the caliper.
Place a shop towel over the piston.
Do not use high
Position the caliper body with the piston facing
pressure air or bring
down and apply small squirts of air pressure to the
the nozzle too close
fluid inlet to remove the piston.
the inlet.
Push the dust and piston seal in and lift them out.
Be careful not to
damage the piston
Clean the seal grooves, caliper cylinder and piston
sliding surface.
with clean brake fluid.
15-42
BRACKET
BOOT
PAD SPRING
DUST SEAL
BOOT
SLEEVE
PISTON SEAL