Mil Circuit Inspection - Honda Transalp XL700V Manual

3. IACV Resistance Inspection
Connect the IACV 4P (White) connector.
Measure the resistance at the test harness termi-
nals.
Connection: A19 – A29
STANDARD: 99 – 121 Ω (25°C/77°F)
Is the resistance within 99 – 121 Ω (25 ° C/77 ° F)?
YES
NO

MIL CIRCUIT INSPECTION

If the engine can be started but the MIL does not
come on when the ignition switch ON and engine
stop switch " ", check the follows:
Check for operation of the combination meter func-
tion properly.
– If they do not function, check the combination
meter power input line (page 20-9).
– If they function properly, check as follows:
Turn the ignition switch OFF.
Disconnect the ECM 33P connectors.
Ground the White/blue wire terminal of the wire
harness side connector with a jumper wire.
TOOL:
Test probe
Turn the ignition switch ON and engine stop switch
" ", the MIL should come on.
– If the MIL come on, replace the ECM with a new
one, and recheck; for Key Registration Proce-
dures (page 21-4).
– If the MIL does not come on, check for open cir-
cuit in White/blue wire between the combination
meter and ECM.
If the wire is OK, replace the combination meter
(page 20-10).
A16 – A27
– Replace the ECM with a new one, and
recheck; for Key Registration Proce-
dures (page 21-4).
– Faulty IACV
07ZAJ-RDJA110
FUEL SYSTEM (PGM-FI)
A16
A27
33P (GRAY) CONNECTOR
33P (BLACK) CONNECTOR
ECM 33P (BLACK) CONNECTOR
(Wire side/female terminal)
W/Bu
A20
A19
A29
5-53