Starter Relay Switch - Honda Transalp XL700V Manual

STARTER RELAY SWITCH

INSPECTION
Remove the left side cover (page 2-4).
Shift the transmission into neutral.
Turn the ignition switch ON with the engine stop
switch at " ".
Push the starter switch button.
The coil is normal if the starter relay switch clicks.
If you do not hear the switch click, inspect the relay
switch using the procedure below.
GROUND LINE
Disconnect the starter relay switch 4P (Red) connec-
tor.
Check for continuity between the Green/red wire
(ground line) terminal and ground.
If there is continuity when the transmission is in
neutral or when the clutch is disengaged and the
sidestand is retracted, the ground circuit of the relay
coil is normal. (In neutral, there is a slight resistance
due to the diode.)
STARTER RELAY VOLTAGE
Connect the starter relay switch 4P (Red) connector.
Shift the transmission into neutral.
Turn the ignition switch ON with the engine stop
switch at " ".
Measure the voltage between the yellow/red wire
terminal (+) and ground (–).
If the battery voltage appears when the starter
switch button is pushed, the power supply circuit of
the relay coil is normal.
ELECTRIC STARTER
STARTER RELAY SWITCH
4P (RED) CONNECTOR
4P (RED) CONNECTOR
19-15