Honda Transalp XL700V Manual page 519

IGNITION SYSTEM
Lift and support the fuel tank (page 3-5).
Rear side:
With the ignition coil primary wires connected, con-
nect the peak voltage tester or adaptor probes to the
ignition coil primary terminal and ground.
TOOL:
Imrie diagnostic tester (model 625) or
Peak voltage adaptor
with commercially available digital multimeter
(impedance 10 MΩ/DCV minimum)
Connection: FRONT: Blue/yellow (+) – ground (–)
Turn the ignition switch ON with the engine stop
switch at " ".
Check the initial voltage at this time.
The battery voltage should be measured.
If the initial voltage cannot be measured, follow the
checks in the troubleshooting table (page 18-4).
Shift the transmission into neutral.
Crank the engine with the starter motor and mea-
sure the ignition coil primary peak voltage.
PEAK VOLTAGE: 100 V minimum
Although measured values are different for each
ignition coil, they are normal as long as voltage is
higher than the specified value.
If the peak voltage is lower than the standard value,
follow the checks in the troubleshooting table (page
18-4).
Install the removed parts in the reverse order of
removal.
18-6
07HGJ-0020100
REAR: Yellow/blue (+) – ground (–)
Front:
Rear: