Engine Stop Relay; Ecm - Honda Transalp XL700V Manual

ENGINE STOP RELAY

INSPECTION
Remove the seat (page 2-4).
Open the fuse box and remove the engine stop
relay.
Connect the ohmmeter to the relay connector termi-
nals.
Connection: A – B
Connect the 12 V battery to the following relay con-
nector terminals.
Connection: C – D
There should be continuity only when the 12 V bat-
tery is connected.
If there is no continuity when the 12 V battery is
connected, replace the relay.

ECM

POWER/GROUND LINE INSPECTION
ENGINE DOES NOT START (MIL NO BLINKS)
1. ECM Power Input Voltage Inspection
• Before starting the inspection, check for loose
or poor contact on the ECM 33P connectors
and recheck the MIL blinking.
Disconnect the ECM 33P connectors (page 5-77).
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage between the ECM 33P
(Black) connector and ground.
Connection: A4 (+) – Ground (–)
TOOL:
Test probe
Is there the battery voltage?
YES
NO
07ZAJ-RDJA110
– GO TO STEP 2.
– GO TO STEP 3.
FUEL SYSTEM (PGM-FI)
ENGINE STOP RELAY
ENGINE STOP RELAY
A
B
ECM 33P (BLACK) CONNECTOR
(Wire side/female terminal)
C
D
A4
5-75