Suspension Linkage - Honda Transalp XL700V Manual

REAR WHEEL/SUSPENSION
INSTALLATION
Install the shock absorber into the frame.
Install the upper mounting bolt and nut.
Tighten the upper mounting nut to the specified
torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
Install and tighten the lower mounting bolt to the
specified torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
Install the mud guard and tighten the screws.
Install the side covers (page 2-4).

SUSPENSION LINKAGE

REMOVAL
Remove the exhaust system (page 2-14).
Support the motorcycle using a hoist or equivalent,
and raise the rear wheel off the ground.
Remove the bolt and lower drive chain slider.
14-16
UPPER MOUNTING BOLT/NUT
SHOCK ABSORBER
MUD GUARD
BOLT
BOLT
SCREWS
SLIDER