Honda Transalp XL700V Manual page 406

WHEEL RIM
Check the rim runout by placing the wheel in a true-
ing stand.
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:
WHEEL BALANCE
Refer to the wheel balance servicing (page 13-17).
Do not add balance weight more than 60 g (2.1 oz)
to the rear wheel.
WHEEL/DRIVEN FLANGE BEARINGS
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer races fit tightly in
the hub or flange.
Remove and discard the bearings if the races do not
Replace the wheel/
turn smoothly and quietly, or if they fit loosely in the
driven flange
hub or flange.
bearings in pairs.
DRIVEN SPROCKET
Check the condition of the final driven sprocket
teeth.
Replace the sprocket if worn or damaged.
• If the final driven sprocket requires replacement,
inspect the drive chain and drive sprocket.
• Never install a new drive chain on a worn
sprocket or a worn chain on new sprockets. Both
chain and sprocket must be in good condition or
the replacement chain or sprocket will wear rap-
idly.
2.0 mm (0.08 in)
REAR WHEEL/SUSPENSION
14-7