Honda Transalp XL700V Manual page 462

Check the bracket pin boot and replace it if it is hard,
deteriorated or damaged.
Install the bracket pin boot and pad spring in the cal-
iper.
If the caliper pin is removed, apply locking agent to
the threads and tighten it.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Apply silicone grease to the caliper and bracket pin
sliding surface.
Assemble the caliper bracket and the caliper body.
INSTALLATION
Install the brake caliper onto the fork leg.
Install new mounting bolts and tighten them to the
specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Connect the brake hoses to the caliper with the oil
bolts and new sealing washers.
Push the stopper or the brake hose eyelet joint
against the caliper body, then tighten the oil bolts to
the specified torque
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the brake pads (page 15-17).
Fill and bleed the hydraulic system (page 15-12).
HYDRAULIC BRAKE
PIN
CALIPER
CALIPER
BOLTS
SEALING WASHERS
SEALING WASHERS
BOOT
PAD SPRING
BRACKET
CALIPER
OIL BOLTS
15-33