IMMOBILIZER SYSTEM (HISS)
HISS INDICATOR
Remove the front center cowl (page 2-12).
Perform the following inspections.
BACK-UP VOLTAGE LINE INSPECTION
Measure the voltage between the Red/green wire
terminal (+) and ground (–).
There should be battery voltage at all times.
HISS INDICATOR LINE INSPECTION
Measure the voltage between the White/red wire
terminal (+) and ground (–) with the combination
meter 20P connector connected.
Turn the ignition switch ON.
There should be battery voltage.
There should be no voltage for approx. two seconds
after the ignition switch is turned ON, then the bat-
tery voltage should appear, if the system is normal.
ECM
Remove the left side cover (page 2-4).
Disconnect the ECM 33P (Black) and 33P (Gray) con-
nectors.
Perform the following inspections at the wire har-
ness side connector of the ECM.
21-12
COMBINATION METER
20P CONNECTOR
R/G
20P CONNECTOR
(Viewed from harness side)
W/R
20P CONNECTOR
(Viewed from harness side)
33P (GRAY) CONNECTOR
33P (BLACK) CONNECTOR