Honda Transalp XL700V Manual page 500

POWER INPUT LINE OPEN CIRCUIT INSPECTION
Measure the voltage between the Red/brown wire
terminal (+) and ground (–).
There should be battery voltage with the ignition
switch ON.
If there is no voltage, check for ABS MAIN fuse.
TOOL:
Test probe
Connection: Red/brown (+) – Ground (–)
GROUND LINE
Measure the continuity between the Green/orange
wire terminals and ground.
There should be continuity.
If there is no continuity, check for open circuit in
Green/orange wires.
TOOL:
Test probe
Connection: Green/orange – Ground
REMOVAL/INSTALLATION
Drain the brake fluid from the front and rear hydrau-
lic systems (page 15-11).
Remove the following:
– Left side cover (page 2-4)
– ECM (page 5-77)
Remove the bolt, bolt/washer, nut, trim clip and
ECM bracket.
Disconnect the ABS modulator 26P connector (turn
the lock lever up to disconnect it).
ANTI-LOCK BRAKE SYSTEM (ABS)
07ZAJ-RDJA110
ABS MODULATOR 26P CONNECTOR
(Wire side/female terminal)
07ZAJ-RDJA110
ABS MODULATOR 26P CONNECTOR
(Wire side/female terminal)
BRACKET
ABS MODULATOR 26P CONNECTOR
R/Br
G/O G/O
NUT
BOLT BOLT/WASHER
16-25
CLIP