Honda Transalp XL700V Manual page 419

REAR WHEEL/SUSPENSION
Apply specified grease to new dust seal lips (page 1-
18).
Install the dust seals and pivot collars.
ASSEMBLY
Install the cushion connecting rod, bolt and nut to
the cushion arm.
Tighten the nut to the specified torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
INSTALLATION
Install the suspension linkage assembly with cush-
When installing the
ion arm "UP" mark facing up.
cushion arm bolt,
lift the drive chain
Install the following:
slider upper side.
– Shock absorber lower mounting bolt
– Cushion arm bolt
– Cushion arm nut
Tighten the shock absorber lower mounting bolt
and cushion arm nut to the specified torque.
TORQUE:
Shock absorber lower mounting bolt
44 N·m (4.5 kgf·m, 32 lbf·ft)
Cushion arm nut
64 N·m (6.5 kgf·m, 47 lbf·ft)
Install the collar and drive chain slider upper side
screw.
Tighten the screw to the specified torque.
TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)
14-20
DUST SEALS
DUST SEALS
CUSHION ARM CUSHION CONNECTING ROD
BOLT
BOLT/NUT SUSPENSION LINKAGE
COLLARS
BOLT/NUT
"UP" MARK
SCREW/COLLAR