Honda Transalp XL700V Manual page 402

SERVICE INFORMATION
GENERAL
• Riding on damaged rims impairs safe operation of the vehicle.
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with a high quality brake degreasing agent.
• When servicing the rear wheel, suspension, or swingarm, raise the rear wheel off the ground by supporting the frame
securely.
• Use only genuine Honda replacement bolts and nuts for all suspension pivot and mounting points.
SPECIFICATIONS
Minimum tire tread depth
Cold tire Driver only
pressure
Driver and passenger
Axle runout
Wheel rim Radial
runout
Axial
Wheel balance weight
Drive chain Size/link
Slack
Shock Installed spring length
absorber
Compression damping adjuster
standard position
TORQUE VALUES
Rear axle nut
Shock absorber upper mounting nut
Shock absorber lower mounting bolt
Swingarm pivot nut
Rear brake disc bolt
Rear wheel pulser ring torx bolt
Driven sprocket nut
Spoke
Cushion connecting rod nut
(frame side)
Cushion arm nut
Cushion connecting rod nut
(cushion arm side)
Shock absorber pre-load adjuster lock nut
Drive chain slider mounting screw
ITEM
REGINA
88 N·m (9.0 kgf·m, 65 lbf·ft)
44 N·m (4.5 kgf·m, 32 lbf·ft)
44 N·m (4.5 kgf·m, 32 lbf·ft)
88 N·m (9.0 kgf·m, 65 lbf·ft)
42 N·m (4.3 kgf·m, 31 lbf·ft)
8 N·m (0.8 kgf·m, 5.9 lbf·ft)
45 N·m (4.6 kgf·m, 33 lbf·ft)
3.7 N·m (0.4 kgf·m, 2.7 lbf·ft)
64 N·m (6.5 kgf·m, 47 lbf·ft)
64 N·m (6.5 kgf·m, 47 lbf·ft)
44 N·m (4.5 kgf·m, 32 lbf·ft)
44 N·m (4.5 kgf·m, 32 lbf·ft)
6 N·m (0.6 kgf·m, 4.4 lbf·ft)
REAR WHEEL/SUSPENSION
STANDARD
–
2
200 kPa (2.00 kgf/cm , 29 psi)
2
280 kPa (2.80 kgf/cm , 41 psi)
–
–
–
–
REG525ZRHB-118LE
35 – 45 mm (1.4 – 1.8 in)
197.4 mm (7.77 in)
2 turns out from full in
U-nut
U-nut
U-nut
ALOC bolt; replace with a new one.
ALOC bolt; replace with a new one.
U-nut
Apply engine oil to the threads.
U-nut
U-nut
U-nut
Unit: mm (in)
SERVICE LIMIT
2.0 (0.08)
–
–
0.20 (0.008)
2.0 (0.08)
2.0 (0.08)
60 g
(2.1 oz) max.
–
–
–
–
14-3