Sidestand Switch - Honda Transalp XL700V Manual

Install the neutral switch with a new sealing washer
and tighten it to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the neutral switch connector.
Install the under cowl (page 2-13).

SIDESTAND SWITCH

INSPECTION
Remove the under cowl (page 2-13).
Disconnect the sidestand switch 2P (Green) connec-
tor.
Check for continuity between the switch side con-
nector terminals.
There should be continuity with the sidestand
retracted and no continuity with the sidestand low-
ered.
REMOVAL/INSTALLATION
Remove the under cowl (page 2-13).
Support the motorcycle on a level surface.
Disconnect the sidestand switch 2P (Green) connec-
tor.
Release the sidestand switch wire from the clamps
(page 1-21).
Remove the bolt and sidestand switch.
Install the sidestand switch by aligning its pin with
the sidestand hole and switch groove with the
bracket pin.
Install and tighten the bolt to the specified torque.
TORQUE: 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
Install the removed parts in the reverse order of
Route the
removal.
sidestand switch
wire properly (page
1-21).
LIGHTS/METERS/SWITCHES
NEUTRAL SWITCH
SEALING WASHER
2P (GREEN) CONNECTOR
(Switch side/male terminal)
G/W
2P (GREEN) CONNECTOR
2P (GREEN) CONNECTOR
SIDESTAND SWITCH
Align
CONNECTOR
G
Align
BOLT BOLT
20-25