Honda Transalp XL700V Manual page 373

Hide thumbs Also See for Transalp XL700V:

Table of Contents

FRONT WHEEL/SUSPENSION/STEERING

Install the handlebar onto the lower holders and

align the punch mark on the handlebar with the top

surface of the lower holder.

Install the upper holder with its punch marks facing

Install the holder bolts and tighten the forward bolts

first, then tighten the rear bolts to the specified

TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)

Tighten the handlebar lower holder nuts to the

specified torque.

TORQUE: 26.5 N·m (2.7 kgf·m, 20 lbf·ft)

Apply Honda bond A or equivalent adhesive to the

inside surface of the handlebar grip and to the clean

surfaces of the left handlebar and throttle pipe.

Wait 3 – 5 minutes and install the grip.

Rotate the grip for even application of the adhesive.

Allow the adhesive

to dry for 1 hour

before using.

Apply grease 0.2 – 0.3 g to the throttle pipe flange

groove and sliding surface.

Install the throttle pipe and connect the throttle

cables to the throttle pipe flange.

Install the throttle housing, aligning the locating pin

with the hole in the handlebar.

THROTTLE PIPE

Show Quick Links

Chapters

Table of Contents

Transalp xl700va