Honda Transalp XL700V Manual page 246

Install the ECM stay.
Install and tighten the nut, bolt/washer and bolt.
Install the trim clip (XL700VA only).
Install the guide plate, drive sprocket cover and
bolts.
Tighten the bolts to the specified torque.
TORQUE: 13 N·m (1.3 kgf·m, 10 lbf·ft)
Install the gearshift pedal to the spindle, aligning
with the punch marks.
Tighten the pinch bolt to the specified torque.
TORQUE: 17.6 N·m (1.8 kgf·m, 13 lbf·ft)
Install the following:
– Heat guard plate (page 2-23)
– Exhaust system (page 2-18)
– Spark plug cap (page 3-9)
– Thermostat housing (page 6-10)
– Radiator (page 6-11)
– Throttle body (page 5-68)
– Fuel tank (page 5-61)
– ECM (page 5-77)
– Both side covers (page 2-4)
Fill the crankcase with engine oil (page 3-12).
Fill and bleed the cooling system (page 6-7).
Check the engine oil level (page 3-12).
ENGINE REMOVAL/INSTALLATION
STAY
BOLT
GUIDE PLATE
PINCH BOLT
Align
NUT
CLIP
(XL700VA)
BOLT/WASHER
COVER
BOLTS
7-13