Fuel Level Sensor Inspection - Honda GL1800 Service Manual

FUEL LEVEL SENSOR INSPECTION

Disconnect the fuel level sensor connector.
Remove the two bolts and shelter setting stay.
Remove the fuel level sensor retainer by turning it
counterclockwise with the special tool.
TOOL:
Fuel sender/pump wrench 07ZMA-MCAA201 or
Remove the fuel level sensor and base gasket from
the fuel tank.
Measure the resistance between the fuel level sen-
sor connector terminals with the float at top (FULL)
and bottom (EMPTY) positions.
RESISTANCE (20° C/68° F):
1.5 – 2.5Ω with the float at FULL position
61.4 – 63.4Ω with the float at EMPTY position
Install a new base gasket.
Install the fuel level sensor in the fuel tank and align
the lugs on the sensor base with grooves in the fuel
tank.
Install the retainer and turn it clockwise with the
special tool until it stops.
Install the removed parts in the reverse order of
removal.
07ZMA-MCAA200
LIGHTS/METERS/SWITCHES
HELTER ETTING TAY
FUEL SENDE /
ETAINE
PUMP W ENCH
GROOVES
ASE GASKET
LOAT
EMPTY
POSITION
20-25