Honda Transalp XL700V Manual page 381

Hide thumbs Also See for Transalp XL700V:

Table of Contents

FRONT WHEEL/SUSPENSION/STEERING

Install the hub covers and brake discs with the

Do not get grease

stamped side facing out.

on the brake disc or

Install new bolts and tighten them in a crisscross

stopping power will

pattern in several steps.

TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)

Install the pulser ring onto the left wheel hub and

XL700VA only:

new torx bolts, then tighten the torx bolts to the

specified torque.

TORQUE: 8 N·m (0.8 kgf·m, 5.9 lbf·ft)

Apply grease to new dust seal lips and install the

dust seals until they are flush with the wheel hub.

INSTALLATION

Install the side collars.

Right side collar is

longer than left side

Place the front wheel between the fork legs.

Be careful not to

Apply thin coat of grease to the axle sliding surface.

damage the wheel

Install and tighten the axle to the specified torque.

speed sensor when

removing the

TORQUE: 64 N·m (6.5 kgf·m, 47 lbf·ft)

If the axle holder is removed, install it with its "UP"

mark facing up.

Show Quick Links

Chapters

Table of Contents

Transalp xl700va