FRONT WHEEL/SUSPENSION/STEERING
Install the left handlebar switch housing, aligning
the locating pin with the hole in the handlebar.
Install the screws.
Tighten the front short screw first, then tighten the
rear long screw.
Install the clutch lever bracket, holder and screws.
Align the edge of the bracket with the punch mark
on the handlebar and tighten the front screw first,
then tighten the rear screw.
Connect the clutch switch connectors.
13-14
SWITCH HOUSING
Align
SCREWS
BRACKET
SCREWS
SWITCH HOUSING
Align
HOLDER
CONNECTORS