Connect the starter motor cable and tighten the ter-
minal nut to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Connect the ground cable and tighten the bolt
securely.
Connect the clutch cable end to the clutch lifter arm.
Install the clutch cable holder and bolt.
Tighten the bolt securely.
Connect the air supply hoses to the PAIR check
valve covers.
Connect the CKP sensor 2P (Red) connector.
Clamp the CKP sensor wire and install the CKP sen-
sor 2P (Red) connector to the under cowl stay.
ENGINE REMOVAL/INSTALLATION
STARTER MOTOR CABLE
RUBBER CAP
CLUTCH CABLE HOLDER
CLUTCH CABLE
Front:
Rear:
AIR SUPPLY HOSES
2P (RED) CONNECTOR
CLAMP
NUT
BOLT
GROUND CABLE
BOLT
7-11