Starter Relay Switch; Operation Inspection; Circuit Inspection; Ground Line - Honda CB HORNET 160R 2015 Shop Manual

STARTER RELAY SWITCH

REMOVAL/INSTALLATION
Remove the left side cover (page 2-3).
Disconnect the negative (–) cable from the battery.
Pull the starter relay from the battery tray.
Disconnect the starter relay switch 4P (Red) connector.
Remove the socket bolts, battery cable and starter motor
cable from the starter relay switch.
Remove the starter relay switch from the stay.
Installation is in the reverse order of removal.

OPERATION INSPECTION

Remove the left side cover (page 2-3).
Shift the transmission into neutral.
Turn the ignition switch to "ON' and push the starter switch.
The coil is normal if the starter relay switch clicks.
If you don't hear the switch click, inspect the relay switch
circuit.

CIRCUIT INSPECTION

GROUND LINE

Turn the ignition switch to "OFF".
Disconnect the starter relay switch 4P (Red) connector.
Check for continuity between the Green/Red wire terminal
of the wire harness side connector and ground.
If there is continuity when the transmission is in neutral
or when the clutch lever is squeezed, the ground circuit
is normal.
ELECTRIC STARTER SYSTEM
STARTER RELAY
SWITCH
STARTER RELAY
SWITCH
4P (RED) CONNECTOR
NEGATIVE TERMINAL
SOCKET BOLTS
STARTER RELAY
SWITCH
NEGATIVE TERMINAL
18-3