Hitachi SH7750 Hardware Manual page 556

Bit 1—Transfer End (TE): This bit is set to 1 after the number of transfers specified in
DMATCR. If the IE bit is set to 1 at this time, an interrupt request (DMTE) is generated.
If data transfer ends before TE is set to 1 (for example, due to an NMI interrupt, address error, or
clearing of the DE bit or the DME bit in DMAOR), the TE bit is not set to 1. When this bit is 1,
the transfer enabled state is not entered even if the DE bit is set to 1.
Bit 1: TE
0
1
Bit 0—DMAC Enable (DE): Enables operation of the corresponding channel.
Bit 0: DE
0
1
When auto-request is specified (with RS3–RS0), transfer is begun when this bit is set to 1. In the
case of an external request or on-chip peripheral module request, transfer is begun when a transfer
request is issued after this bit is set to 1. Transfer can be suspended midway by clearing this bit to
0.
Even if the DE bit has been set, transfer is not enabled when TE is 1, when DME in DMAOR is 0,
or when the NMIF or AE bit in DMAOR is 1.
For channel 0, in DDT mode this bit is set to 1 when a DTR format is received. DE remains set to
1 even if TE is set to 1. When the mode is switched from DDT mode to normal DMA mode (DDT
bit = 0 in DMAOR), the DE bit must be cleared to 0.
Rev. 6.0, 07/02, page 506 of 986
Description
Number of transfers specified in DMATCR not completed
[Clearing conditions]
•
When 0 is written to TE after reading TE = 1
•
In a power-on or manual reset, and in standby mode
Number of transfers specified in DMATCR completed
Description
Operation of corresponding channel is disabled
Operation of corresponding channel is enabled
(Initial value)
(Initial value)