Register Configuration; Register Descriptions; Receive Shift Register (Scrsr2); Table 16.2 Scif Registers - Hitachi SH7750 Hardware Manual

16.1.4

Register Configuration

The SCIF has the internal registers shown in table 16.2. These registers are used to specify the
data format and bit rate, and to perform transmitter/receiver control.

Table 16.2 SCIF Registers

Name
Serial mode register
Bit rate register
Serial control register
Transmit FIFO data register SCFTDR2 W
Serial status register
Receive FIFO data register SCFRDR2 R
FIFO control register
FIFO data count register
Serial port register
Line status register
Notes: *1 Only 0 can be written, to clear flags. Bits 15 to 8, 3, and 2 are read-only, and cannot be
modified.
*2 The value of bits 6, 4, and 0 is undefined.
*3 Only 0 can be written, to clear flags. Bits 15 to 1 are read-only, and cannot be modified.
16.2

Register Descriptions

16.2.1

Receive Shift Register (SCRSR2)

Bit:
R/W:
SCRSR2 is the register used to receive serial data.
The SCIF sets serial data input from the RxD2 pin in SCRSR2 in the order received, starting with
the LSB (bit 0), and converts it to parallel data. When one byte of data has been received, it is
transferred to the receive FIFO register, SCFRDR2, automatically.
SCRSR2 cannot be directly read or written to by the CPU.
Abbrevia-
tion R/W
SCSMR2 R/W
SCBRR2 R/W
SCSCR2 R/W
R/(W) *
SCFSR2
SCFCR2 R/W
SCFDR2 R
SCSPTR2 R/W
R/(W) *
SCLSR2
7 6 5
— — —
Initial P4
Value Address
H'0000 H'FFE80000 H'IFE80000 16
H'FF H'FFE80004 H'IFE80004 8
H'0000 H'FFE80008 H'IFE80008 16
Undefined H'FFE8000C H'IFE8000C 8
1
H'0060 H'FFE80010 H'IFE80010 16
Undefined H'FFE80014 H'IFE80014 8
H'0000 H'FFE80018 H'IFE80018 16
H'0000 H'FFE8001C H'IFE8001C 16
2
H'0000 *
H'FFE80020 H'IFE80020 16
3
H'0000 H'FFE80024 H'IFE80024 16
4 3
— —
Rev. 6.0, 07/02, page 661 of 986
Area 7 Access
Address Size
2 1 0
— — —