Show Interface Managementethernet - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Table 5-8. Fields in Output of show interface ethernet unit/slot/port Command
Field
RST BPDUs Transmitted
RSTP BPDUs Received
MSTP BPDUs Transmitted
MSTP BPDUs Received
Dot1x Statistics
EAPOL Frames Received
EAPOL Frames Transmitted
Time Since Counters Last Cleared
Related
ip address (management)
Commands
show interface
show interface switchport
show interfaces

show interface managementethernet

This command displays information about the management address of the switch.
show interface managementethernet
Syntax
Mode Privileged Exec
Command
Version 2.3
History
The display parameters of the show interface command, when the keyword is
Usage
managementethernet, are as follows:
Information
Table 5-9. Fields in Output of show interface managementethernet command
Field
IP Address
Subnet Mask
Default Gateway
Burned In MAC Address
Description
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
Rapid Spanning Tree Protocol Bridge Protocol Data Units received
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
Multiple Spanning Tree Protocol Bridge Protocol Data Units
received
The number of valid EAPOL frames of any type that have been
received by this authenticator
The number of EAPOL frames of any type that have been
transmitted by this authenticator
The elapsed time, in days, hours, minutes, and seconds since the
statistics for this port were last cleared
Configures the IP address of the management interface.
Displays statistics for a specific port.
Displays a summary of statistics on Layer 2 interfaces.
Displays information about a selected interface or VLAN
Modified: Added the keyword
the information that had been available through the
Description
The IP address of the interface. The factory default value is 0.0.0.0
The IP subnet mask for this interface. The factory default value is 0.0.0.0
The default gateway for this IP interface. The factory default value is
0.0.0.0
The burned in MAC address used for in-band connectivity
managementethernet
to
show network
System Management Commands | 57
show interface
to provide
command.