Dell Force10 S2410-01-10GE-24P Command Reference Manual page 153

mode dot1q-tunnel
Syntax
Default
disabled
Mode Interface Config
Command
Version 2.5.2
History
Version 2.5.1
Usage By default, all ports become core ports. To configure a particular port as an access port, enable
Information
DVLAN tagging in Interface Config mode for that port with this command.
Related
show dot1q-tunnel
Commands
show dvlan-tunnel
l2pdu-forwarding
mode dvlan-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.This command performs the same function as mode
dot1q-tunnel.
The no version of this command is used to disable Double VLAN Tunneling on the specified interface.
By default, Double VLAN Tunneling is disabled.
mode dvlan-tunnel
Syntax
Default
disabled
Mode Interface Config; Interface Port Channel Config
Command
Version 2.5.2
History
Version 2.5.1
Usage By default, all ports become core ports. To configure a particular port as an access port, enable
Information
DVLAN tagging in Interface Config mode for that port with this command.
Related
show dot1q-tunnel
Commands
show dvlan-tunnel
l2pdu-forwarding
Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Displays information about Double VLAN Tunneling for a specified
interface or for all interfaces.
Displays the current l2pdu tunneling configuration present on the switch.
Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Modified: Added Interface Port Channel Config mode.
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Displays information about Double VLAN Tunneling for a specified
interface or for all interfaces.
Displays the current l2pdu tunneling configuration present on the switch.
VLAN Commands | 153