Downloading To The Switch Through Xmodem; Downloading From A Tftp Server - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Downloading to the Switch through XMODEM

To download through the switch console port from a PC, use the following command:
Command Syntax
copy xmodem://filepath/
filename {nvram:startup-config |
image1 | image2}
See copy on page 106.

Downloading from a TFTP Server

Before starting a TFTP server download, complete the Quick Start-up for the IP Address.
To download from a TFTP server, use the following command:
Command Syntax
copy tftp://ipaddress/filepath
{nvram:startup-config |
image1 | image2}
See copy on page 106.
The software download option
was expressed before SFTOS
2.5.1 as system:image.
Note:
Keywords and parameters that are shown within braces in syntax statements must be
entered in the CLI. Keywords and parameters that are shown separated by a bar in syntax
statements indicate that you choose only one. For details, see
on page 23.
Command Mode
Privileged Exec
Command Mode
Privileged Exec
Purpose
Sets the destination (download) data type to be an image (
image2
or ) or a configuration file (
If you are using HyperTerminal, specify which file is to be sent to the
switch.
The switch will restart automatically after the code has been
downloaded.
Note:
The software download option was expressed before
SFTOS 2.5.1 as copy xmodem://filepath/filename
system:image.
Purpose
Sets the destination (download) datatype to be a software image
image1 image2
( or ) or a configuration file
nvram:startup-config
( ).
The URL must be specified as:
tftp://ipaddress/filepath
(where
such as s50/s50software.bin)
nvram:startup-config
The
file.
copy tftp://ipaddress/filepath image1
The
image1
the code to the storage location in the switch.
Command Syntax Conventions
image1
nvram:startup-config
filepath
includes the filename,
option downloads the configuration
option downloads
Quick Start | 21
).