Ip Multicast Ttl-Threshold; Disable Ip Multicast Mdebug Mtrace - Dell Force10 S2410-01-10GE-24P Command Reference Manual

The combination of the sourceipaddr and the mask fields specify the network IP address of the
multicast packet source. The groupipaddr is the IP address of the next hop toward the source. The
metric is the cost of the route entry for comparison with other routes to the source network and is a
value in the range of 0 and 255. The
multicast packets matching this multicast static route entry.
The no ip multicast staticroute sourceipaddr command deletes a static route in the static mcast
table. The sourceipaddr is the IP address of the multicast packet source.
Default
none
Mode Global Config

ip multicast ttl-threshold

This command applies the given ttlthreshold to a routing interface.
ip multicast ttl-threshold ttlvalue
Syntax
The ttlthreshold is the TTL threshold which is to be applied to the multicast Data packets which are to
be forwarded from the interface
The no ip multicast ttl-threshold command applies the default ttlthreshold to a routing interface.
The ttlthreshold is the TTL threshold which is to be applied to the multicast Data packets which are to
be forwarded from the interface
Default 1
Mode Interface Config

disable ip multicast mdebug mtrace

This command is used to disable the processing capability of mtrace query on this router. If the mode is
enable, the mtrace queries received by the router are processed and forwarded appropriately by the
router. If the mode is disable, this router does not respond to the mtrace queries it receives from other
router devices.
•noY disable ip multicast mdebug mtrace
Syntax
The no version of this command is used to enable the processing capability of mtrace query on this
router. If the mode is enable, the mtrace queries received by the router are processed and forwarded
appropriately by the router. If the mode is disable, this router does not respond to the mtrace queries it
receives from other router devices.
Default none
Mode Global Config
incoming interface is used for RPF checking for
current
The value for ttlthreshold has range from 0 to 255.
.
.
IP Multicast Commands | 459