Dell Force10 S2410-01-10GE-24P Command Reference Manual page 149

Mode User Exec; Privileged Exec
Command
Version 2.5.1
History
Example Figure 7-50. Example of Output from the show switchport protected Command
(Force10) #show switchport protected 0
Name.........................................willstest
Member Ports :
1/0/10
Field Name
characters long, including blanks. The default is blank.
Descriptions
Member Ports–List of ports, which are configured as protected for the group identified with
no port is configured as protected for this group, this field is blank.
Related
switchport protected (Global Config)
Commands
switchport protected (Global Config)
Use this command to create and name a protected port group that includes all ports on the switch.
[no] switchport protected groupid [name name ]
Syntax
Parameters
groupid
name name
Use the no switchport protected command to remove a protected port group. Alternatively, use the
name name pair to remove the name from the group.
Default unprotected
Mode
Global Config
Command
Version 2.5.1
History
Introduced
An optional name of the protected port group. The name can be up to 32 alphanumeric
–
Note:
Port protection occurs within a single switch. Protected port configuration does not
affect traffic between ports on two different switches. No traffic forwarding is possible
between two protected ports.
Introduced
Create a protected port group that includes all ports on the switch
Identify the set of protected ports.
Range: 0–2
(OPTIONAL) Assign a name to the protected port group.
Default: blank
Range: up to 32 alphanumeric characters long, including blanks
. If
groupid
VLAN Commands | 149