Lldp Mode (Interface); Lldp Multiplier - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command
Version 2.5.1
History
Related
clear lldp neighbors
Commands

lldp mode (interface)

show lldp local-device
lldp mode (interface)
Enable LLDP on the selected port (timers not supported on one interface).
protocol is enabled on sent packets, received packets, or both.
[no] lldp mode {tx | rx | both}
Syntax
tx
Parameters
rx
both
Not enabled; when enabled, both is the default.
Default
Mode
Interface Config
Command
Version 2.5.1
History
Related
clear lldp neighbors
Commands
lldp mode (global)
show lldp local-device

lldp multiplier

This command sets the TTL (time to live) in local data LLDPDUs.
lldp multiplier integer
Syntax
The integer parameter is the multiplier on the hello transmit interval. It sets the number of consecutive
hello misses before LLDP declares the interface dead.
Range: 1–10
Default 4
The multiplier is automatically enabled when the lldp mode command is executed in either the global
or interface mode. If you change the integer value to a non-default value, it takes effect immediately.
Then, if you disable LLDP, the value resets to the default.
Mode Global Config
Introduced
Clear LLDP neighbor information.
Enable/disable LLDP on a selected port.
Display LLDP neighbor information.
Enable/Disable LLDP transmit capability.
Enable/Disable LLDP receive capability.
Enable/Disable LLDP both transmit and receive capabilities.
Introduced
Clear LLDP neighbor information.
Enable/disable LLDP globally.
Display LLDP neighbor information.
Set whether the LLDP
Link Layer Discovery Protocol (LLDP) Commands | 161