Dell Force10 S2410-01-10GE-24P Command Reference Manual page 252

Default
Mode
Command
History
Related
Commands
set garp timer leave
Syntax
Default
Mode
Command
History
Related
Commands
| GARP Commands
252
The no version of this command sets the GVRP join time per port and per GARP to 20 centiseconds
(0.2 seconds). This command has an effect only when GVRP is enabled.
20 centiseconds
Interface Config, Global Config; Interface Port Channel Config; Interface Range, which is indicated by
the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.5.2
Version 2.5.1
Version 2.3
interface range
This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6
seconds.
set garp timer leave
20-600
Use no set garp timer leave to set the GVRP leave time per port to 60 centiseconds (0.6 seconds).
60
Note:
This command has an effect only when GVRP is enabled.
Interface Config;
Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.5.2
Version 2.5.1
Version 2.3
interface range
Unsupported: not tested in 2.5.2
Added Interface Port Channel Config mode
Unsupported: not tested in 2.5.1
Interface Range mode added
Defines an interface range and accesses the Interface Range mode
Unsupported: not tested in 2.5.2
Added Interface Port Channel Config mode
Unsupported: not tested in 2.5.1
Interface Range mode added
Defines an interface range and accesses the Interface Range mode