Distance Rip; Default-Information Originate (Rip); Default-Metric (Rip) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

default-information originate (RIP)

Syntax
Mode

default-metric (RIP)

Syntax
Mode

distance rip

Syntax
Default
Mode
distribute-list out
Syntax
| RIP Commands
450
This command is used to control the advertisement of default routes.
The no version of this command is used to control the advertisement of default routes.
[no] default-information originate
Router RIP Config
This command is used to set a default for the metric of distributed routes.
The no version of this command is used to reset the default metric of distributed routes to its default
value.
default-metric <0-15>
no default-metric
Router RIP Config
This command sets the route preference value of RIP in the router. Lower route preference values are
preferred when determining the best route.
The no version of this command sets the default route preference value of RIP in the router.
distance rip <0-255>
no distance rip
15
Router RIP Config
This command is used to specify the access list to filter routes received from the source protocol.
The no version of this command is used to specify the access list to filter routes received from the
source protocol.
[no]u distribute-list <1-199> out {ospf | static | connected}