Dell Force10 S2410-01-10GE-24P Command Reference Manual page 461

The default value of group is 224.2.0.1.
Mode
Privileged Exec
no ip mcast mroute
This command is used to clear entries in the mroute table. The all parameters is used to clear all entries.
no ip mcast mroute {group groupipaddr | source sourceipaddr [ groupipaddr ] | all}
Syntax
The source parameter is used to clear the routes in the mroute table entries containing the specified
sourceipaddr or sourceipaddr
the multicast packet. The group address is the Group Destination IP address of the multicast packet.
The group parameter is used to clear the routes in the mroute table entries containing the specified
groupipaddr. The group address is the Group Destination IP address of the multicast packet.
Default
none
Mode Global Config
show ip mcast
This command displays the system-wide multicast information.
show ip mcast
Syntax
Mode Privileged Exec and User Exec
Admin Mode—This field displays the administrative status of multicast. This is a configured value.
Report Fields
Protocol State—This field indicates the current state of the multicast protocol. Possible values are
Operational or Non-Operational.
Table Max Size—This field displays the maximum number of entries allowed in the multicast table.
Number Of Packets For Which Source Not Found—This displays the number of packets for which the
source is not found.
Number Of Packets For Which Group Not Found—This displays the number of packets for which the
group is not found.
Protocol—This field displays the multicast protocol running on the router. Possible values are PIMDM,
PIMSM, or DVMRP.
Entry Count—This field displays the number of entries in the multicast table.
Highest Entry Count—This field displays the highest entry count in the multicast table.
groupipaddr
pair. The source address is the source IP address of
[ ]
IP Multicast Commands | 461