Resetting to Factory Defaults
Command Syntax
clear config
reload
(or cold boot of the switch)
|
Quick Start
22
To help configure factory defaults, use one of the following commands:
Command Mode
Privileged Exec
Privileged Exec
Purpose
yes
Enter
when the prompt pops up to clear all the configurations
made to the switch. This option replaces the current running-config
with the most recent startup configuration file. However, if the
startup configuration file has been modified from the factory
default settings, this command does not restore the system to
factory defaults.
yes
Enter
when the prompt pops up that asks if you want to reset
the system.
Choose to reset the switch or cold boot the switch—both work
effectively. See
reload on page
chapter of the SFTOS Configuration Guide.
111, and see the Getting Started